Yaskawa SI-W3 - Manual (Page 11)

4 Option Components
YASKAWA ELECTRIC TOBP C730600 56A 1000-Series Option SI-W3 Installation Guide 11
◆
Terminal Block CN1
The communication terminal is a pluggable terminal block that serves as the connection
point of the LONWORKS network communication cable to the option.
Table 2 Terminal Descriptions
◆
Connector CN3 for Digital Operator
DANGER! Electric Shock Hazard. Do not touch drive main terminals and control terminals. Failure to
comply will result in death or serious injury.
Connecting the CN3 and the digital operator (model: JVOP-182) lets the user set the DDC
function parameters.
◆
Service Switch
This is a neuron ID output switch. Pressing this switch outputs the neuron ID to the network.
■ Initializing Bind Data
Cycling power to the drive while holding down the service switch will clear the bind data,
and reset the configuration properties back to the factory settings.
Note: Do not turn off the power to the drive while initializing the bind data. The RUN, RX, TX, and
ERR LEDs are lit (ON) during initialization of the bind data.
Terminal Terminal No. Name Description
1 A Signal Line A
2 SLD Shield
3 B Signal Line B
1
2
3
TOBP_C730600_56A_0_0_E.fm 11 ページ ２０１１年１１月２日 水曜日 午後６時１０分