Yaskawa V1000-Series Option SI-EP3/V PROFINET - Manual (Page 53)

10 Web Interface
YASKAWA TOEP YEACOM 06A V1000 Option PROFINET SI-EP3/V Installation Manual 53
■ Procedure: Conditional Email Set-up
1.
Define the condition that will trigger the email by selecting a monitor parameter, a
comparator, and a value. Set up comparator values for the range of values to check
in the chosen condition. If choosing only one condition and no OR or AND are
needed, set the “OR/AND” drop-down selection to “NotUsed”.
2.
Enter the email address where the alert will be sent.
3.
Enter the message that will appear in the email contents.
4.
Enter the email subject.
5.
Click the “Email Active” check box to enable the alert.
Clicking “Save to device” will save the entered information into the option memory.
Clicking “Cancel and reload” will cancel any pending edits and display the most recently
saved settings from the option board.
■ Doc Links Tab (option firmware version VST800250 and prior)
The Doc links tab contains links to the option documentation on the Yaskawa website.
Figure 47
Figure 47 Doc Links Tab View
SI-EP3