Yaskawa F7 Configured Drive - Manual (Page 3)

Yaskawa Electric America, Inc – www.drives.com
IG.F7C.01 Page 3 of 7
Date: 3/5/04
Heatsink Filter Kit Option
For F7 Configured Drive
Heatsink Filter Kit Installation
(1) Turn OFF the power supply to the Drive by completely removing power to the enclosure. Wait 5 minutes for
capacitor discharge.
(2) Unpack and verify the contents of the heatsink filter kit.
Refer to Figures 3a and 3b – Removal of mounting screws
(3) Open enclosure using (2) quarter turn latches on door of enclosure
(4) Locate the screws that attach the enclosure to the back panel. Three screws exist at the top of the enclosure
(Figure 3a), and three at the bottom of the enclosure (Figure 3b). Remove only the center screw from both
the top and bottom of the enclosure, as shown below. These screws will no longer be used once the heatsink
filter kit in installed.
Remove screw
from upper rear
flange
Figure 3a – Upper screw Removal (Step 4)
Remove screw
from lower rear
flange
Figure 3b – Lower screw Removal (Step 4)