Yaskawa GPD515C-XXXX-CS009 - Manual (Page 3)

Verifying Installed Software Number:
For the continuous dynamic braking software option,
the software number is 12020. The software version
installed in the drive can be verified by either reading it
off of the control board, or calling it up on the Digital
Operator.
In order to read the software number off of the control
board, take the cover off of the drive and look for the
white sticker on the main control board. This sticker is
just to the right of connector 2CN. On it is the version
of the control board, then a dash, then the software
number (see Figure 1). The "S" before the number
can be disregarded.
In order to view the software number from the Digital
Operator, bring up drive parameter U1-14 (FLASH ID).
This is done by powering up the drive and using the
following key sequence:
Press , then ,
then , then ,
then 13 times.
NOTICE TO USER:
Be sure to keep this document with your GPD 515 Technical Manual.
This Page: | Change | 0 | 4/18/97 | Page 3 of 3 Doc. No. 02Y00025-0425
MENU
DATA
ENTER
DATA
ENTER
Figure 1. Software Number Location
on Control Board