Yaskawa DS383 - Manual (Page 4)

DWG. NO. 02Y00025-0350
SHEET NO. 4 OF 6
R E L . 0 5 / 0 5 / 9 3
( m - df ) Refer to Sheet 1 for latest change.
CAUTION
TO PREVENT ERRONEOUS OPERATION CAUSED BY NOISE
INTERFERENCE, USE SHEILDED CABLE FOR CONTROL
SIGNAL WIRING, AND LIMIT DISTANCE TO 50M (165 FEET) OR
LESS.
Route wires from the drive and connect to the peripheral device(s). Refer to "Electrical Installation" in the drive’s
technical manual for further information on use of shielded cable.
6. Adjustments.
A. GPD 515: There are no adjustments to be made on the Digital Output option; however, drive parameter
F6-01 will have to be reprogrammed for the desired output signal content. See Table 3.
Table 3. Programming For DO-08 Outputs
F6-01 Output
Setting Type
Terminals Output Contents
0 Fixed TD5 - TD11 Overcurrent (SC, OC, GF)
Data TD6 - TD11 Overvoltage (OV)
TD7 - TD11 Drive Overload (OL2)
TD8 - TD11 Fuse Blown (FU)
TD9 - TD11 not used
TD10 - TD11 Overheat (OH)
TD1 - TD2 Zero-speed
TD3 - TD4 Speed at set frequency
1 Coded TD5 - TD11 Bit 0
Output TD6 - TD11 Coded Output Bit 1
TD7 - TD11 (See Table 4) Bit 2
TD8 - TD11 Bit 3
TD9 - TD11 Zero-speed
TD10 - TD11 Speed at set frequency
TD1 - TD2 Running
TD3 - TD4 Minor fault