Yaskawa DS383 - Manual

DWG. NO. 02Y00025-0350
SHEET NO. 1 OF 6
R E L . 0 5 / 0 5 / 9 3
( m - df )
For GPD 515, GPD 503, or GPD 575
Adjustable Frequency Drives
or VCD 703
Vector Control Drives
CHANGE RECORD
1 STD-5688 1-24-94
2 STD-6602 6-13-96
DIGITAL OUTPUT CARD (DO-08)
MODEL DS383
Before installing this option, a TECHNICALLY QUALIFIED INDIVIDUAL, who is familiar with this type of
equipment and hazards involved, should READ this ENTIRE INSTRUCTION SHEET.
IMPORTANT
This option may have been installed by the factory. However, certain steps can
only be completed at the installation site. Therefore, review and then perform
those steps which complete the installation process.
INTRODUCTION
When installed, this option allows the user to employ isolated type digital signals to monitor status outputs of the
drive (alarm signal, zero-speed detection, etc.).
This option card can be used on a GPD 515 drive, a GPD 503 drive, a GPD 575 drive, or a VCD 703 drive.
CAUTION
The option card uses CMOS IC chips. If proper electrostatic discharge
(ESD) protective procedure is not used when handling the card, the ICs
may be damaged, resulting in erratic performance of the drive.
INSTALLATION
1. Disconnect all electrical power to drive.
2. Remove drive front cover. Check that the CHARGE indicator lamp inside the drive is off.
3. Verify voltage has been disconnected by using a voltmeter to check for voltage at incoming power terminals
(L1, L2, L3).
WARNING
HAZARDOUS VOLTAGE CAN CAUSE SEVERE INJURY OR
DEATH. LOCK ALL POWER SOURCES FEEDING DRIVE IN
"OFF" POSITION.
NOTE: If this option is being installed on a GPD 515 with speed feedback, the speed feedback card needs to
be temporarily un-installed to allow access to the connector 2CN on the drive’s Control Board and terminals
TD1 through TD11 on the option card.