Yaskawa Copy Unit Model for GPD 503 User Manual
Copy unit, Model no. ds596, Figure 1. copy unit
DWG. NO. 02Y00025-0415
SHEET NO. 1 OF 5
R E L . 1 0 / 2 8 / 9 6
( m - df )
For GPD 333
and GPD 5 0 3
Adjustable Frequency Drives
CHANGE RECORD
DATA
DISPLAY
JOG
COPY
MODE
RESET
F / R
VRFY
DRIVE
PRGM
SWITCH
ENTER
READ
RUN
COPY
STOP
REMOTE
COPY UNIT
JVOP-105
SEQ REF
DRIVE FWD REV
COPY UNIT
MODEL NO. DS596
Before installing this option, a TECHNICALLY QUALIFIED INDIVIDUAL, who is familiar with this type of
equipment and hazards involved, should READ this ENTIRE INSTRUCTION SHEET.
INTRODUCTION
When installed, the Copy Unit (DS596) is used to read out constant settings from a drive and to copy them into
other drives easily from a remote location, up to 9.8 ft (3 m) from the drive. The Copy Unit is similar to Digital
Operator, Model No. DS393.
NOTE: Constants cannot be read from and copied to different types of drives.
EXAMPLE: GPD 333 ———> GPD 503.
IMPORTANT
The appropriate length Remote Operator Cable for connecting the Copy Unit, and the Remote
Interface Panel, Model DS390 (for the GPD 333), must be ordered separately.
Figure 1. Copy Unit