SMA WBP-Box - Manual (Page 21)

SMA Solar Technology AG 9 Decommissioning
Installation Guide WBP-Box-IEN103320 21
9 Decommissioning
9.1 Removing the Windy Boy Protection Box
1. Stop the small wind turbine system (see the manufacturer manual).
2. Decommission the wind power inverter (see the manual for the wind power inverter).
3. Loosen the screws of the enclosure lid and carefully remove the lid. Disconnect the enclosure lid
PE from the Windy Boy Protection Box when doing so.
4. Disconnect the small wind turbine system from the Windy Boy Protection Box.
5. Disconnect the wind power inverter from the small wind turbine system (see the manual for the
wind power inverter).
6. Disconnect the load resistor and the load resistor cable shield from the
Windy Boy Protection Box.
7. Disconnect PE from the Windy Boy Protection Box.
8. Place the enclosure lid onto the enclosure and secure with screws.
9. Loosen all fixing screws.
10. Lift the Windy Boy Protection Box from the upper fixing screws.
9.2 Packaging the Windy Boy Protection Box
• Package the Windy Boy Protection Box in the original packaging if available.
• If the original packaging is not available, use a box that is suited to the weight and dimensions
of the Windy Boy Protection Box.
9.3 Storing the Windy Boy Protection Box
Requirements for the storage location:
☐ The storage location is dry.
☐ The ambient temperature is between − 25 °C and 65 °C.
9.4 Disposing of the Windy Boy Protection Box
• Dispose of the Windy Boy Protection Box in accordance with the applicable disposal
regulations for electronic waste.
or
• Return the Windy Boy Protection Box to SMA Solar Technology AG with shipping paid by the
sender. When doing so, label the packaging "ZUR ENTSORGUNG" ("FOR DISPOSAL").