Electrolux 65011 VI - Manual (Page 30)

Fault code and malfunction Possible cause and solution
• continuous flashing of the light of the run-
ning programme
• point-shaped optical signal is flashing
•
appears in the digital display.
• intermitted audible signal
The dishwasher does not fill with water.
• The water tap is blocked or furred with lime-
scale.
Clean the water tap.
• The water tap is turned off. Turn the water tap
on.
• The filter (where present) in the threaded hose
fitting at the water inlet valve is blocked.
Clean the filter in the threaded hose.
• The water inlet hose has not been correctly
laid or it is bent or squashed.
Check the water drain hose connection.
• continuous flashing of the light of the run-
ning programme
• point-shaped optical signal is flashing
•
appears in the digital display.
• intermitted audible signal
The dishwasher will not drain.
• The sink spigot is blocked.
Clean out the sink spigot.
• The water drain hose has not been correctly
laid or it is bent or squashed.
Check the water drain hose connection.
• continuous flashing of the light of the run-
ning programme
• point-shaped optical signal is flashing
•
appears in the digital display.
• intermitted audible signal
Anti-flood device is activated.
• Close the water tap and contact your local
Service Force Centre.
The programme does not start. • The dishwasher’s door has not been properly
closed. Close the door.
• The main plug is not plugged in. Insert the
main plug.
• The fuse has blown out in the household fuse
box.
Replace the fuse.
• Delay start has been set.
If dishes are to be washed immediately, cancel
the delay start.
The flashing of the point-shaped optical signal on the floor beneath the dishwsher's
door will not be visible if the appliance has been installed higher up with a furniture
door mounted flush.
30 What to do if…