beautypg.com

Front loop handle removal, Operation, Hedge trimming – Echo 99944200490 User Manual

Page 9

background image

P

ower

B

lower

A

ttAchment

o

PerAtor

'

s

m

AnuAl

9

2. Control blower speed with throttle trigger.

3. Use lower speed to blow debris from hard surfaces.

4. Additional speed may be necessary to clean debris, snow, etc.

from lawns and flowerbeds.

NOTE

Never use a higher speed setting than necessary to perform a task.

Remember, the higher the engine speed, the louder the blower

noise. Minimize dust by using blower at lower speeds. Keep debris

on your property.

Be Smart - be a good neighbor.

o

peratIon

WARNING

Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from all

openings. Always stop engine, disconnect spark plug, and make sure all moving parts have come to a complete

stop before removing obstructions, clearing debris, or servicing unit. Blower housing may contain shredder blades

and other sharp edges that can cause serious injuries if touched, even if engine is off and blades are not moving.

Wear gloves to protect hands from sharp edges and hot surfaces.

operatIng

blower

WARNING

Always wear safety glasses, hearing protection and a face fil-

ter mask or serious personal injury may result. Do not point the

blower pipe in the direction of people or pets.

Read the Safety Section carefully.

IMPORTANT

To avoid engine damage due to over-revving, do not block blower

pipe.

1. Use only during appropriate hours.

IMPORTANT

Use reduced speed only when performing light-duty tasks or to

comply with local noise regulations. Continuous low speed opera-

tion may allow fuel/oil residue to build-up on the piston and cause

rapid build-up of carbon on the spark arrestor screen, resulting

in overheating and engine damage. To reduce harmful build-up,

run engine at wide open throttle for at least 5 minutes every hour,

and inspect/clean the spark arrestor screen after approximately 40

hours of operation.