SMA SBSE-AT-BatteryPack - Manual (Page 2)

SMA Solar Technology AG
2 SBSE-AT-BatteryPack-SG-en-10 Service Manual
7. Remove the power cable from the defective Battery Pack. Turn the plug lock to the left until the
plug releases and then pull the plug out of the pin connector.
8. If the protective caps of the pin connectors for the data cable and the power cable are
available, use them to cover the corresponding pin connectors of the defective Battery Pack.
9. Insert the data cable and power cable into the bracket on the left-hand side of the inverter.
10. Remove the defective Battery Pack vertically upwards from the wall mounting bracket.
Mounting the New Battery Pack and Connecting It to the Inverter
1. Remove the new Battery Pack from the packaging and put the packaging aside. Be careful
when handling the packaging as you will need this later for packaging the defective
Battery Pack.
2. Hang the new Battery Pack to the left of the inverter in the wall mounting bracket. The right-hand
side of the Battery Pack must be flush with the hook-in position marked on the wall mounting
bracket.
3. Remove the protective caps from the pin connectors for the data cable and power cable and
retain them for possible decommissioning.
4. If the protective caps of the defective Battery Pack are no longer available, place the protective
covers of the new Battery Pack on to the pin connectors of the defective Battery Pack.
5. Release the data cable and the power cable from the bracket on the inverter.
6. Insert the power cable plug in the pin connector for the power cable. Insert the plug into the pin
connector and turn the lock to the right until the plug snaps into place.
7. Ensure that the plug is securely in place.
8. Connect the data cable for communication between the inverter and the Battery Pack to the
D-sub plug of the Battery Pack.
9. The plug snaps audibly into place.
11. Position the protective cover over the Battery Pack. The brackets on the right-hand side of the
protective cover must engage with the guides on the left of the inverter enclosure. Then press the
left side of the protective cover down onto the Battery Pack until it snaps into place.
10.
Danger of crushing if the Battery Pack is jolted
• Grip the Battery Pack by the handles and carefully push it to the right as far as the stop.