SMA FANKIT02-10 - Manual (Page 17)

SMA America, LLC 5 Installation
Installation Manual FANKIT02-IA-US_en-12 17
5.2.2 Installing the Fan to the Inverter
1. Disconnect the inverter from voltage sources (see the inverter installation manual).
2. Loosen the screws of the lower enclosure lid and remove the enclosure lid.
3. Loosen the screw on the display and flip the display
up until it clicks into place.
6. Grab behind the inverter from the bottom side.
Slide the fan into the fan guard from the right-hand
side.
☑ The fan snaps audibly into place.
7. Unscrew the counternut from the supplied cable
gland for the fan cable.
The fan guard is not required for Sunny Boy 7000/7700TL-US
4. Before installation push the fan out of the fan guard from the rear side.
Correct airflow direction
5. The arrow and type label on the fan must point upwards before installation.