SMA 20000TL Quick Installation Guide - Manual (Page 33)

STP20-25TL-IS-xx-10 33
H Wechselrichter in Betrieb nehmen | Commissioning the Inverter | Θέση σε λειτουργία του μετατροπέα | Puesta en
marcha del inversor | Mise en service de l’onduleur | Messa in servizio dell’inverter | Omvormer in bedrijf stellen |
Uruchamianie falownika | Colocar o inversor em funcionamento | Прием в эксплуатацию инвертора |
การเริ่มต้นการทำางานของอินเวอร์เตอร์ | Eviricinin devreye alınması | Az inverter üzembe helyezése
1
3 mm
2 Nm ± 0,3 Nm
1
2
5
6
3
4
2
2
1
1
ON
3
OK
4
I System-Daten | System Data | Στοιχεία συστήματος | Données du système | Dati del sistema | Systémové
údaje | Dados do sistema | Datos del sistema | System-data | System-data | Системные данные |
ข้อมูลระบบ | Sistem verileri | Rendszeradatok
Topology transformerless
Overvoltage category according to IEC 62109-1 II (DC), III (AC)
Protection class in accordance with IEC 62109-1 I
All-pole sensitive residual-current monitoring unit integrated
Maximum permissible value for relative humidity, non-condensing 100 %
Extended humidity range according to IEC 60721-3-4 0 % … 100 %
Pollution degree outside the enclosure 2
Pollution degree inside the enclosure 3
Standard requirements
NRS 97-2-1: This standard requires a separate
label attached to the AC distribution board, which
indicates the AC-side disconnection of the inverter
in case of a grid failure (for further details, see
NRS 97-2-1, Sect. 4.2.7.1 and 4.2.7.2)