Electrolux EHD90LLUM - Manual (Page 21)

Troubleshooting
Problem Possible cause Remedy
The appliance cannot
be switched on or is not
operating
More than 10 seconds have
passed since the appliance
was switched on
Switch the appliance on again
The lock is switched on Switch off the lock (See the
section “Locking/unlocking the
control panel”)
The child safety device is
switched on
Deactivate child safety device
(See the section “Child safety
device”)
Several sensor fields were
touched at the same time
Only touch one sensor field
Safety cut-out has been
triggered
Remove any objects (pan,
cloths, etc.) that are lying on
the control panel. Switch the
appliance on again
The cooking zones
automatically reduce the
cooking level to
The sensor fields are partly
covered by a damp cloth or
with liquid
Remove the cloth or the
liquid. Reset the cooking level
required
The residual heat indicator is
not displaying anything
The cooking zone was only
on for a short time and is
therefore not hot
If the cooking zone is
supposed to be hot, call the
Customer Service Department
Acoustic signal sounds,
appliance switches off
One or more sensor fields have
been covered for longer than
10 seconds
Uncover sensor field
Acoustic signal sounds and
appliance switches itself on
and after 10 seconds off again
The On/Off sensor field has
been covered up,
e.g. by a cloth
Do not place any objects on
the control panel
Display is switching between
two heat settings
Power management is
reducing the power of this
cooking zone
See the section “Switching
the power boost function on
and off”
lights up Unsuitable cookware Use suitable cookware
No cookware on the cooking
zone
Place cookware on the
cooking zone
The diameter of the bottom of
the cookware is too small for
the cooking zone
Move onto a smaller cooking
zone
Use suitable cookware
electrolux induction cooktop troubleshooting 17