Electrolux EHG 65 - Manual (Page 9)

9
ON/OFF SWITCH
FLEX
OUTLET
ON/OFF SWITCH
FLEX
OUTLET
FO 0763
1 2
Building In
Building over a cupboard or
drawer
If the hob is to be installed above a cupboard or drawer it
will be necessary to fit a heat resistant board below the
base of the hob on the underside of the work surface.
It is also recommended to carry out the electrical
connection to the hob as shown in diagrams 1 and 2.
Building over a kitchen unit with
door
Proper arrangements must be taken in designing the
furniture unit, in order to avoid any contact with the bottom
of the hob which can be heated when it is operated. The
recommended solution is shown in diagram 3.
The panel fitted under the hob ("a") should be easily
removable to allow easy access if technical assistance
is needed. The space behind the kitchen unit ("b") can
be used for connections.
Rectangular cut-out size for hob
550
470
55 min.
30
R 60
20
117
FO 2098
Dimensions are given in mm.
Cut Out Size
The dimensions of the cut-out are given in the diagram.
30
20 min 60
a
b
FO 1013
3
FO 0199
a
Fitting the Hob into the worktop
F
Carry out the building in of the hob as follows:
• put the seals supplied with the hob, on the edges of
the cut out: place them exactly on the front and rear
edge and at 50 mm. from the side edges, taking care
that the seals meet without overlapping;
• place the hob in the cut out, taking care that it is
centred;
• fix the hob with the relevant fixing clamps and screws,
as shown in the diagram. When the screws have been
tightened, the excess seal can be removed.
The edge of the hob forms a double seal which prevents
the ingress of liquids.
a) Sealing gasket