Polaris 2016 600 Switchback Assault 144 - Manual (Page 104)

102
MAINTENANCE
Fuse Replacement
If the engine stops or will not start, or if an electrical component fails to
operate, a fuse may need replacement. Locate and correct any damage
or short circuits that may have caused the blown fuse, then replace the
fuse.
NOTICE: Always replace a blown fuse with a new fuse having the same
amperage rating of the blown fuse. Never replace a fuse with a fuse of
a higher amperage rating.
Constant Power Fuse
Models equipped with electric start or an IDD have a battery/electric
start wire harness. The 2 amp constant power fuse is located in the hood
harness. This fuse protects KEY ON power at the ignition switch. KEY
ON power supplies battery voltage to the IDD and GPS puck.
If the IDD does not turn on when the key is in the ON position, check
for a blown fuse. If the fuse is blown, inspect the constant power circuit.
Repair or replace any damaged components before replacing the fuse.