Polaris 2005 RMK - Manual (Page 46)

43
PRE-RIDE INSPECTIONS
Before Starting the Engine
n
Hydraulic Brakes
Properly functioning brakes
are critical to your safety.
Always check the following
items to assure proper
operation before starting the
engine.
Brake Lever Travel
When the brake lever is
squeezed, it should move no
closer to the handgrip than
1/2″ (1.3 cm) (A). A
distance less than this indicates low brake fluid level or air in the
hydraulic system. Refer to the brake bleeding information on page 89.
Lever Feel
A hydraulic system multiplies the force of your hand squeezing the
brake lever. Proper operation depends on an adequate supply of air and
moisture-free hydraulic brake fluid in the system. If the brake lever
feels “spongy” when squeezed, check the level and condition of the
fluid. Also check for the presence of air in the fluid system. Refer to
page 89 for more information, or see your dealer for service.
Replace brake fluid at least every two years. All DOT 3 brake fluid is
not alike. We recommend the use of Polaris DOT 3 high temperature
brake fluid. See page 112 for the part numbers of Polaris products.
WARNING
Continued use of “spongy” brakes may cause a complete loss of
brakes, which could result in serious injury or death. Always have
the brakes serviced at the first sign of sponginess.
A