Electrolux 3173-4GS - Manual (Page 12)

Installation
12
Electrical connection
1 WARNING – THIS APPLIANCE MUST BE EARTHED
Please ensure that the voltage and current indicated on the rating
plate agree with the voltage of your electricity supply.
220/240 volts (i. e. 220/240V AC).
If your appliance has been equipped with a mains lead with a moulded
on type plug, you must comply with the following regulations:
The plug moulded on to the cord incorporates a fuse. For replacement,
use a 13 amp BS 1362 fuse. Only ASTA approved or certified fuses
should be used. The fuse cover/carrier must be replaced in the event of
changing the fuse. The plug must not be used if the fuse cover/carrier
ist lost. A replacement cover/carrier must be obtained from an electri-
cal goods retailer. If the socket outlets in your home are not suitable
for the plug fitted to the appliance, then the plug must be cut off and
an appropriate one fitted. When fitting the plug please note the
following points:
Important
The wires in the mains lead are coloured in accordance with the
following code:
Green and Yellow Earth
Blue
Neutral
Brown Live
As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in
your plug, proceed as follows:
1. The wire which is coloured green and yellow must be connected to
the earth terminal in your plug, which is marked with the letter E or
by the earth symbol
or coloured green, or green and yellow.
Blue
Green
& Yellow
Brown
Cord Clamp