Grass Valley PAC 216 Upgrade - Manual (Page 14)

PAC 216 Upgrade Installation
6 PAC 216 Upgrade Installation
Install Mounting Brackets
Use the following procedure to remove the bracket screws from the motherboard
and then install the mounting brackets.
1. Use the Torx tool with the T15 tip to remove the three screws from the
motherboard inside the chassis (
Ê
in Figure 2).
2. Install the three mounting brackets (
Ë
in Figure 2) using the three screws
removed in step 1. Make sure to orient the dimple on the bottom of the
bracket with the corresponding hole in the motherboard.