Removing the chassis cover – Grass Valley PAC 216 Upgrade User Manual

Page 12

PAC 216 Upgrade Installation

Removing the Chassis Cover

To remove the chassis cover, refer to Figure 1 and:

1. Turn PAC200 power off and remove the power cord.

2. Use the Torx tool with the T15 tip to remove the four screws from the chassis

cover: two on top and two in the rear, as shown in Figure 1.

NOTE: Take care not to lose these chassis screws. They are required to meet
the EMI specifications for the PAC 208.

3. Lift the cover from the chassis and set aside.