Epson 73c - Manual (Page 50)

44 Fine-tuning the Projector
6. When you see the message “Select this image?” select Yes and
press Enter . If you want to change the area selected, select No ,
press Enter and repeat steps 4 through 6.
7. Use the directional buttons on the remote control to select a zoom
rate (display size), and then press Enter .
8. When you see the message “Save image as user’s logo?,” select Yes
and press Enter . Saving the logo may take a few minutes. Do not
use the projector or other sources (computer, video, etc.) while
the logo is being saved.
9. When you see the message “Completed,” press Esc or Menu .
Selecting When the Image Displays
After your image is saved, you can set it up as the no-signal message
and/or the screen that’s displayed when you press the
A/V Mute
button.
1. Press the Menu button to display the main menu (if not already
displayed).
2. Use the directional buttons to highlight Setting .
3. Press Enter to select the Setting menu.
4. Use the directional buttons to highlight No-Signal Msg .
5. Use the directional buttons to select Logo; then press the Enter
button. This sets your image as the screen displayed when the
projector is not receiving a signal.
6. If you want to set up your image as the A/V Mute display, use the
directional buttons to move down to A/V Mute .
7. Use the directional buttons to select Logo; then press the Enter
button. This sets your image as the screen displayed when you
press the
A/V Mute button.
8. When you’re finished, press Esc or Menu .
To test your setting, press the A/V Mute button to display your image.
Press it again to turn off the image.
note
You can also set up your
image as a startup screen.
Use the Advanced menu to
enable the startup screen; see
page 46.