Gpi / tally connections, Control panel dc power in frame dc power out – Grass Valley Kayak HD Installation Planning Guide v.6.9.2 User Manual
Page 47
Kayak HD — Installation Planning Guide
43
GPI / Tally Connections
Control Panel DC Power In
Frame DC Power Out
GPI / Tally Connections
The Kayak HD GPI / Tally system has universal relays that interface source
tally and GPI Output information to an external system through the Tally
Port connectors. The channels can be assigned in the Setup menu.
Tallies are a source attribute and relays can be assigned to a source when
source definitions are defined in the Setup menu during initial system con-
figuration. The nominal rating specification for each relay is 1A, 60 V.
The GPI (General Purpose Interface) and Tally Interface provides a means
to transfer commands to and from the switcher to external customer pro-
vided equipment. A “one wire per function” parallel hardware connection
is used.
Connectors and pins are provided to create a mating connector.
Table 12.
Socket
Pin
Signal
A1
48 V (+)
A2
48 V (-)
1
-
2
-
3
-
4
-
5
-
Table 13.
Socket
Pin
Signal
A1
48 V (+)
A2
48 V (-)
1
-
2
-
3
-
4
-
5
-
Pin A2
Pin 2
Pin 1
Pin A1
Pin 5
Pin 3
D-Sub Male
Pin A1
Pin 1
Pin 2
Pin A2
Pin 3
Pin 5
D-Sub Female