Gpi / tally connections, Kayak hd gpi and tally interface – Grass Valley Kayak HD Installation Planning Guide v.6.9.4 Jun 02 2011 User Manual
Page 45
Kayak HD — Installation Planning Guide
45
GPI / Tally Connections
Control Panel DC Power In
Frame DC Power Out
GPI / Tally Connections
The Kayak HD GPI / Tally system has universal relays that interface source
tally and GPI Output information to an external system through the Tally
Port connectors. The channels can be assigned in the Setup menu.
Tallies are a source attribute and relays can be assigned to a source when
source definitions are defined in the Setup menu during initial system con-
figuration. The nominal rating specification for each relay is 1A, 60 V.
The GPI (General Purpose Interface) and Tally Interface provides a means
to transfer commands to and from the switcher to external customer pro-
vided equipment. A “one wire per function” parallel hardware connection
is used.
Connectors and pins are provided to create a mating connector.
Kayak HD GPI and Tally Interface
The Kayak HD is highly modular and configurable. This document
describes various possibilities for tally interconnections.
Table 12.
Socket
Pin
Signal
A1
48 V (+)
A2
48 V (-)
1
-
2
-
3
-
4
-
5
-
Socket
Pin Signal
A1
48 V (+)
A2
48 V (-)
1
-
2
-
3
-
4
-
5
-
Pin A2
Pin 2
Pin 1
Pin A1
Pin 5
Pin 3
D-Sub Male
Pin A1
Pin 1
Pin 2
Pin A2
Pin 3
Pin 5
D-Sub Female