Epson A882181 - Manual (Page 17)

2. Turn the monitor around so you are looking at the back, as
shown below.
AC power inlet D-sub VGA connector
3. Locate the connector cable and the power cord that came with
the monitor.
4. Plug one end of the video interface cable monitor into the
monitor’s D-sub VGA connector. Tighten the screws on the
cable connector.
5. Plug the other end of the video interface cable into the D-sub
VGA connector on the back of your computer. Then tighten
the two screws on the connector cable. (See your computer or
video adapter card manual for more detailed instructions.)
6. Plug the monitor’s power cord into the AC power inlet on
the back of the monitor.
7. Plug the other end of the power cord into a properly grounded
electrical outlet.
Note
The monitor contains a universal power supply, so you can
connect it to any power supply in the range of 100 to
260 VAC with a 50 to 60 Hz line frequency.
8 17” Super VGA Color Monitor