Grass Valley KXO-HDM Dec 20 2012 - Manual (Page 7)

3
KXO-HDM
Installation Instructions
Before you start, make sure that you have a Phillips #1 screwdriver at hand, and that you are
wearing a static control wrist strap. Allow approximately 15 minutes to complete the
installation.
To install the KXO-HDM on a KXO-Dual card
1 Lay your KXO-Dual card on a work surface.
2 Remove the small PCB (KX-JTAG PULLUP, part no. 1770-5500-100), next to the battery, in
the area near the bottom ejector, by gently pulling it away from the card.
The mezzanine is installed in the lower left corner of the card.
3 Locate the two mezzanine connectors as shown below.
Not needed for installation
on a legacy KXO-Dual card
KX-JTAG PULLUP
Battery