Grass Valley KXO-HDM Dec 20 2012 - Manual (Page 5)

1
KXO-HDM Installation
The KXO-HDM kit includes all parts required to install a dual channel HD-SDI monitoring
mezzanine on a KXO-Dual or KXO-Dual3 module, to add HD-SDI monitoring outputs to
your Kaleido-X multiviewer. The multiviewer must have version 4.06 or later of the Kaleido-
X Software.
Summary
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Installing the KXO-HDM on a First-Generation KXO-Dual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Replacing the KXO-HDM on a First-Generation KXO-Dual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Installing the KXO-HDM on a KXO-Dual3 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Replacing the KXO-HDM on a KXO-Dual3 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
Introduction
The KXO-Dual supports the following HD-SDI output resolutions: 1080i 50/60, and 720p
50/60. The KXO-Dual3 supports 1080p 50/60, 1080i 50/60, and 720p 50/60. When you
install the KXO-HDM mezzanine on a KXO-Dual3, 1080p support involves connecting the
mezzanine’s two coaxial cables to the appropriate connectors on the KXO-Dual3 card. If you
install the mezzanine on a KXO-Dual card, then these cables are not used and require no
manipulation.
Installation instructions
• If your card’s assembly number is between
0792-0100-400 and 0792-0100-599, follow
this procedure: Installing the KXO-HDM on a First-Generation KXO-Dual on page 2.
• For assembly numbers
0792-0100-600 and above, follow this procedure:
Installing the
KXO-HDM on a KXO-Dual3 on page 7.
Replacement instructions
• If your card’s assembly number is between
0792-0100-400 and 0792-0100-599, follow
this procedure: Replacing the KXO-HDM on a First-Generation KXO-Dual on page 5.
• For assembly numbers
0792-0100-600 and above, follow this procedure:
Replacing the
KXO-HDM on a KXO-Dual3 on page 11.
To find your assembly number, look at the underside of the board near the bottom ejector
(see picture below). The assembly number is printed on a small white label.
Note: The DIP switches that were used to set the SDI output format with
earlier versions of the Kaleido-X Software are not relevant anymore and their
configuration can be safely ignored.