Grass Valley Kaleido-X16 Quick Start v.7.80 - Manual (Page 22)

10
Setting Up Your Kaleido-X16 Multiviewer
Networking Setup
To change the IP address of the Kaleido-X16 from the monitor wall
1 Connect a mouse to one of the USB connectors of the Kaleido-X16.
2 Connect a keyboard to one of the USB connectors of the Kaleido-X16.
3 Right-click anywhere on the monitor wall, point to Monitor wall (if you clicked a
monitor), and then click System configuration.
The System Configuration window appears.
4 Click the Ethernet tab.
5 Type the required frame IP address, network mask, and gateway address in the
appropriate boxes.
6 Click OK.
7 When prompted to restart the system to apply your changes, click Yes.
Finding the System IP Address and Application Version
To find the system IP address and application version
1 Connect a mouse to a USB connector: either the USB at the front of the frame or one of
the two USB connectors on the rear connector panel.
2 Right-click anywhere on the monitor wall. On the shortcut menu, point to Monitor wall
(if you clicked a monitor), and then click Show dashboard to display the dashboard
associated with the current head. A small window appears, revealing the frame IP
address and the system version. Take note of these values—they will be used later in
the configuration process.
Display from output (partial view) showing dashboard at the bottom right