Electrolux EWN 14780 W - Manual (Page 37)

installation electrolux 37
6. Open the porthole, take out the inlet
hose from the drum and remove the
polystyrene block fitted with the
adhesive tape on the door seal.
7. Fill the smaller upper hole and the two
large ones with the corresponding
plastic plug caps supplied in the bag
containing the instruction booklet.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the
machine is not impeded by carpets,
rugs etc.
Check that the machine does not touch
the wall or other kitchen units. Level the
washing machine by raising or lowering
the feet. The feet may be tight to adjust
as they incorporate a self locking nut,
but the machine MUST be level and
stable.
Any necessary adjustment can be made
with a spanner. If necessary, check the
setting with a spirit level.
HEC0005
HEC0010
Accurate levelling prevents vibration,
noise and displacement of the machine
during operation. Never place
cardboard, wood or similar materials
under the machine to compensate for
any unevenness in the floor.
Water inlet
An inlet hose is supplied and can been
found inside the machine drum.
Do not use the hose from your
previous machine to connect to the
water supply.
1. Open the porthole and extract the
inlet hose.
2. Connect the hose with the angled
connection to the machine.
Do not place the inlet hose
downwards. Angle the hose to the
left or right depending on the
position of your water tap.
3. Set the hose correctly by loosening
the ring nut. After positioning the inlet
hose, be sure to tighten the ring nut
again to prevent leaks.
HEC0006
HEC007S
132972160 EN.qxd 30/03/2007 15.43 Pagina 37