Grass Valley K2 Storage SAN and Direct-Connect - Manual (Page 25)

Cable K2 RAID
Before cabling, install the K2 RAID chassis in its permanent location. After mounting the chassis
in the rack, you must secure brackets to the front rail to support the Grass Valley bezel. Refer to the
K2 10G RAID Instruction Manual for rack mount instructions.
On the 10G RAID, you do not need to manually set a Fibre Channel address ID on controllers or a
chassis address on Expansion chassis.
As directed by the system diagram for your K2 storage, cable the K2 RAID devices using the
instructions in this section.
Once the RAID storage is connected and configured, do not swap Expansion chassis or otherwise
reconfigure storage. If you connect an Expansion chassis in a different order or to the wrong
controller, the controller will see a configuration mismatch and fault.
Related Links
K2 RAID for basic K2 SAN on page 25
K2 RAID for redundant K2 SAN on page 27
K2 RAID for basic nearline K2 SAN on page 28
K2 RAID for redundant nearline K2 SAN on page 29
K2 RAID for K2 client direct-connect storage on page 30
K2 RAID for basic K2 SAN
These cabling instructions apply to the following:
• K2 RAID (Condor with 10G controller) on a basic (non-redundant) online or production K2
SAN.
18 November 2010 K2 Storage Cabling Guide 25
Cable K2 devices