Grass Valley FIO-991P - Manual (Page 17)

GUIDE TO INSTALLATION AND OPERATION
FIO-991p | 13
Installing an SFP module
1. Make sure that the bale clasp lever is in the
closed position
2. Position the SFP module so that the recessed slot is lined up with
the tab side of the socket.
3. Slide the module straight into the socket, and push gently until it
clicks into position.
Connecting the fiber optic cables
1. Remove the dust plug from the SFP module if present
2. Verify that the exposed end of the optical fiber in the LC connector
is clean
•
Carefully remove any debris if necessary.
3. Plug the LC-terminated fiber optic cable into the SFP module
Removing the fiber optic cables
1. Grasp the LC fiber optic connector that is plugged into the SFP
module, and pull it straight out to disengage the optical fiber from
the SFP.
•
Never pull the fiber optic cable itself, as catastrophic damage
may occur.
2. Insert a dust plug into the SFP module.
Removing the SFP module
1. Move the bale clasp lever to the open
position.
2. Grasp the SFP module between your thumb and forefinger, and
pull it straight out of the slot.