Grass Valley 3-CCD CameraMan Rev.C - Manual (Page 32)

Chapter 3
26 CameraMan 3-CCD Presenter Camera System Installation and Operations
Other Configurations
The following configurations, like the panning orien-
tation, would apply to your specific application need.
Before changing the autoTRACK Window size, you
will need to power up the tracking ring package. See
“Tracking Ring Package” on page 29.
FIGURE 3.3 Default PAN/TILT
Maximum Pan/Tilt Travel Once the CameraMan camera is installed, you can
configure the maximum PAN/TILT settings to the
application. The camera has a maximum PAN range
of 359
o
, but comes programmed with factory default
settings of
o
of PAN and
o
of TILT, as shown
above. If desired, use the following procedure to
change the maximum position settings:
1. Press and hold SETUP.
2. Press and hold one of the PAN/TILT arrows until
achieving the desired maximum position.
3. Release SETUP.
4. Listen for two beeps to indicate that the maxi-
mum position for that direction has been set.
90 ± 25 ±