Grass Valley 3-CCD CameraMan Rev.C - Manual (Page 27)

071838600
June 2005 21
Configuring the Main Docking Station
Before you can begin to use your new Presenter
Camera System, you need to configure its compo-
nents.
There are two settings on the back of the Main
Docking Station which must be set as follows:
1. Set the RF CHANNEL switch to the desired
channel. This must match the setting on the
Tracking Ring Power Pack. If you experience
any problems on one of the channels, switch
both to the alternate channel. (Factory Default:
UP position/one dot)
2. Set the AUDIO LEVEL switch to the desired
audio output.
• To have a mic-level audio signal, set this
switch to MIC.
• To have a line-level audio output, set this
switch to LINE.
Chapter 3
Configure Your Presenter System