Ericsson A1228LX - Manual (Page 12)

Not for commercial use – Ericsson Inc.
Getting Started 9
Align the small plug on the charger cord with the con-
nector on the bottom of your phone. The connector
on the phone is above the lightning bolt symbol.
Press the plug into the connector until the plug
“snaps” into place. The battery icon is alternated with
the
icon.
Note! Do not twist while inserting or removing the small plug
on the charger cord!
Continue charging the phone until the battery is fully
charged.
Note! The battery is being charged when the battery icon is
alternating with the
icon. The battery is fully
charged when the icon is constant.
To disconnect the charger, lift the plug connected to
the phone upwards (1) and pull it out (2).
Charge-Only Mode
If your phone is off, attaching the charger will cause the
phone to activate in charge-only mode. When this mode
is activated the message Charging Only appears in
the display. Your phone is now fast (rapid) charging the
battery. When your battery is fully charged, Battery
Charged
appears in the phone’s display.
Note! You cannot make or receive calls when your phone is in
charge-only mode.
Slow (Trickle) Charging a Deeply
Discharged Battery
The battery may become deeply discharged (for exam-
ple, when the battery is stored for a long period). As a
result, the phone may not activate charge-only mode
when the charger is connected.
Attach the charger to the phone for several hours to
slowly charge (trickle charge) the battery.
After trickle charging the battery for several hours the
phone should activate the charge-only mode automat-
ically.
Continue charging the phone until the battery is fully
charged.
Note! If the phone is in charge-only mode, Battery
Charged
appears in the display when the battery is
fully charged.