Grass Valley 8945EDA v.1.3.0 - Manual (Page 16)

16 8945EDA/-D — Instruction Manual
Cabling
Cabling
Cabling to the 8945EDA or 8945EDA-D module is done on the BNCs on the
8900WE-R rear module. Refer to
Figure 5 on page 17 for a detailed illustra-
tion of the rear connections referenced below. The 8945EDA or 8945EDA-D
will accept any of the video standards listed in the Input specifications in
Table 5 on page 33 .
Inputs and Outputs
The 8945RDA has one input and eight outputs. Refer to Table 2 and
Figure 5 on page 17 for cabling information.
The 8945RDA-D has two inputs each with four outputs. Refer to Table 2
and Figure 6 on page 17 for cabling information. It may also be configured
as a single DA (see Local Configuration on page 13 or Settings Web Page on
page 27 ).
The 8945EDA or 8945EDA-D inputs conform to the video standards listed
in the input specifications in
Table 5 on page 33 ..
Table 2. Cabling Inputs and Outputs
Model Number Inputs Outputs
8945EDA J9 (J10 is not used) J1, J2, J3, J4, J5, J6, J7, J8
8945EDA-D (Dual Mode)
J9 (DA 1) J1, J3, J5, J7
J10 (DA 2) J2, J4, J6, J8
8945EDA-D (Single Mode) J9 or J10 set for single mode J1, J2, J3, J4, J5, J6, J7, J8