Grass Valley 8912RDA - Manual (Page 11)

8912RDA/RDA-D Instruction Manual 11
Power Up
Power Up
The front LED indicators and configuration switches are illustrated in
Figure 4 . Upon power-up, the green PWR LED should light and the yellow
CONF LED should illuminate for the duration of module initialization.
Operation Indicator LEDs
With factory default configuration and a valid input signal connected, the
green PWR LED, and one or both of the green signal Channel Lock LEDs
should illuminate when phase lock is achieved for valid AES/EBU input
signals (refer to
Table 1 on page 12 to see the possible operating indicator
combinations).
The yellow COMM LED, when flashing, indicates communication is active
on the frame bus. The LED also goes into a steady long interval flash when
the module receives a Location command from the remote control system,
providing easy visual identification of the module in a rack with multiple
8900 frames.
Figure 4. LEDs and Testpoints
A red FAULT LED indicates an error situation and, with the previously
described LEDs, can indicate the operational conditions presented in
Table 1 on page 12 . The table describes LED indications and the signal
input/output conditions that are indicated.
8157_05
FAULT (red)
COMM (yellow)
PWR (green)
+5 V testpoint
Channel 1 lock (green)
Channel 2 lock (green)
1/2 amp
125 V fuse
F2