Ensemble Designs BrightEye 33 Analog Audio Distribution Amplifier - Manual (Page 5)

www.ensembledesigns.com
BrightEye 33 - Page 5
Analog Audio Distribution Amplifier User Guide TM BrightEye 33
OPERATION
Monitoring of the BrightEye 33 is performed from the front panel as illustrated in the figure below.
This is a simple device with no interface to the BrightEye Control application. There are no adjustments
required for this unit.
BrightEye 33 Front Panel
Front Panel Controls
Gain
The gain can be adjusted from the front panel for Channel 1 or Channel 2. To adjust gain, insert a small
tool into the recessed potentiometer and rotate clockwise to increase gain or counterclockwise to
decrease gain.
Front Panel Indicators
The front panel of the BrightEye 33, shown in the figure above, provides the following status indicator.
Pwr (Power)
Illuminates green when power is applied to the unit and the internal voltage regulator is functioning
correctly.
For Unbalanced Audio to a RCA Phono Input
To connect the audio output to a consumer audio connector such as an RCA phono jack, connect the
pins as follows:
• Attach Ground from Pin 1 of the Audio Out to the shell, Shield or Ground of the RCA Phono
jack.
• Attach the + (plus) signal from Pin 2 of the Audio Out to the center pin of the RCA Phono jack.
• The – (minus) signal is not used in this application.