Ensemble Designs 4110 ASI Distribution Amplifier - Manual (Page 4)

Model 4110 DVB-ASI DA
4110-4
INSTALLATION
Plug the 4110 module into any one of the slots in the 1 RU or 3 RU frame and install the
plastic overlay provided onto the corresponding group of rear BNC connectors associated
with the module location. Note that the plastic overlay has an optional adhesive backing
for securing it to the frame. Use of the adhesive backing is only necessary if you would
like the location to be permanent and is not recommended if you need to change module
locations. This module may be hot-swapped (inserted or removed) without powering down
or disturbing performance of the other modules in the system.
CABLING
Refer to the 3 RU and 1 RU backplane diagrams of the module below for cabling
instructions. Note that unless stated otherwise, the 1 RU cabling explanations are
identical to those given in the 3 RU diagram.
Connect the DVB-ASI
signal to be distributed to
the DVB-ASI In BNC.
Connect DVB-ASI
output destinations to
the outputs at BNCs
Out 1 – Out 8.
3 RU Backplane
1 RU Backplane