Electrolux EKC60752 - Manual (Page 53)

52
The blade scraper
K EEP THE BLADE SCRAPER OUT OF
THE REACH OF CHILDREN . Use the
blade scraper with care, the blade is
extremely sharp.
Use the scraper to remove anything that has
boiled over and stuck on the ceramic glass
plate. Do not use the scraper or other sharp
implements on the silicon edge since this
implies a safety risk and can cause damage.
HOW TO USE THE BLADE SCRAPER
:
1 Pull back the guard so that the blade is
visible
( SEE ILLUSTRATION ).
2 Make sure that the blade is clean and
whole, otherwise it could damage the
plate. You can buy new blades at a
hardware store.
3 Hold the scraper at an angle of about
45° and scrape clean. You can press
the blade hard against the plate
without damaging it.
4 Carefully wipe off any dirt from
the blade with kitchen tissue.
5 After use, press the guard forward so
that it covers the blade. Store the
scraper out of the reach of children.
REPLACING THE BLADE :
1 Open the scraper by fully loosening
the screw (no screwdriver needed) and
fitting the new blade at the front edge.
2 Assemble the scraper and tighten
the screw again.
3 Press the guard as far forward as it
will go to protect the blade.