Atlantic Water Gardens SH1450 - Manual (Page 4)

• WARNING:
RISK OF ELECTRIC SHOCK - THIS PUMP IS SUPPLIED WITH A GROUNDING CONDUCTOR
AND GROUNDING-TYPE ATTACHMENT PLUG. TO REDUCE THE RISK OF ELECTRIC SHOCK,
BE CERTAIN THAT IT IS CONNECTED ONLY TO A PROPERLY GROUNDED, GROUNDING
TYPE RECEPTACLE.
Electrical Safety
• Electrical wiring should be installed by a qualified electrician in
accordance with all applicable safety regulations. Incorrect wiring can
lead to a pump malfunction, electrical shock or fire.
• Pumps should operate on a designated, 110/120 volt circuit rated at
15 Amps (minimum).
• Pump must be protected by a ground fault circuit interrupter (GFCI).
• Pump must be plugged into a standard, properly grounded, three
pronged outlet.
• Do not cut the electrical cable. If a cable with cut insulation or other
damage is submerged in water, there is danger of water seeping into
the pump motor and causing a short. This may result in damage to the
pump, electrical shock or fire. Altering the electrical cable in any way
will void the warranty.
• Never move or handle the pump by pulling on the electrical cable.
Make sure the electrical cable does not become excessively bent or
twisted, does not rub against a structure in a way that might damage it,
and does not come in contact with heated surfaces.
Operation
• SH-Series pumps are for use in water only. Water temperature should
never exceed 95 degrees F.
• SH-Series pumps must not be used to pump salt water, sewage,
flammable or corrosive liquids, greases, oils or food waste.
• Pay careful attention to the water level while the pump is operating.
The pump must be fully submersed at all times of operation. The pump
must never be allowed to run dry.
4