Atlantic Water Gardens SH1450 - Manual (Page 3)

Prior to Operation and Installation
• When the pump is delivered, first perform the following checks.
• Check for any damage to pump and power cable that may have
occurred during the shipment.
• Check the model number to make sure it is the product that was
ordered and verify the voltage and frequency are correct.
Caution
• DO NOT operate this product under any condition other than
those for which it is specified. Failure to observe this precaution can
lead to electrical shock, electrical leakage, fire, water leakage or
other problems.
• The pump is a 100/120 volt 60 Hz pump, please only use with a power
supply voltage within 100-120 volt 60 Hz.
• Never place your hand or any object in or near the inlet opening while
this equipment is operating. If pump inlet is clogged, always turn off
the power supply and wait until the motor is completely stopped before
attempting to remove any clogged material.
• Please make sure that the power plug and the AC outlet receptacle is
protected and away from water or pump discharge hose to prevent
accidental electric shock or short circuit.
• Always operate the pump completely submerged in water.
• Avoid dry operation, which will not only lower performance but can
cause the pump to overheat/malfunction, leading to electrical leakage,
shock or premature failure.
• CAUTION:
THIS PUMP IS TO BE USED IN A CIRCUIT PROTECTED BY A GROUND CIRCUIT INTERRUPTER.
• ATTENTION:
CETTE POMPE DOIT ETRE BRANCHEE A UNE DERIVATION PROTEGEE PAR UN
DISJONCTEUR DIFFERENTIEL.
• CAUTION:
THIS PUMP HAS BEEN EVALUATED FOR USE IN WATER ONLY.
3