ARM Electronics XR&HD480 Series - Manual (Page 6)

6
Dome Camera Control
Dome Camera Connection & Settings:
• See section Pin Definition of Alarm I/O & RS-485 for RS-485 port pin definition.
• Refer to the following figure. Connect the R+, R− terminals on the dome camera to the D+, D−
terminals on the RS-485 port by RS-485 cable respectively.
• To set up dome camera’s protocol and ID, press MENU to access the OSD main menu, and
select <Camera Setup>. Then select <Dome Protocol> and choose the corresponding
protocol. Next select <Dome ID> and choose a preferred ID number. Note that the ID number
must match the ID address defined by the dome camera.
• To configure the RS-485 parameters, select <System Setup> from OSD main menu, and then
select <RS485 Setup>. The default RS-485 settings are 9600 Baud, 8 Data Bits, 1 Stop Bit and
No Parity.
Control Buttons in Dome Camera Control Mode:
1 Set / Go Preset 5 Zoom In 9 Iris Open 13
Enter Dome Camera
Control Mode
2 Toggle Hint Screen 6 Focus Far 10 Enter / Auto
3
Go Presets 1~6
7
Focus Near
11
Pan / Tilt
4 Zoom Out 8 Iris Close 12 ESC