ARAG BRAVO 300S / Orchard sprayer Direct connection Installation - Software ver. 3.x - Manual (Page 7)

7
6.2 Monitor position
BRAVO 300S must be placed in the control cabin of the farming machine. Observe the following
precautions:
- DO NOT install the monitor in areas where it would be subjected to excessive
vibrations or shocks, to prevent any damage or accidental use of the control keys;
- Install the device in a visible position within easy reach by hand; bear in mind that
the computer should not obstruct the operator’s freedom of movement or block his
view.
Consider all necessary connections of the computer (Fig. 2 and 3), the cable length,
and make sure there is enough space for connectors and cables.
An identification symbol is located next to each connector to indicate its function.
For any reference to the system configuration read Par. 6.1 - System recommended
composition.
Fig. 4
iteM Monitor connection points
1 Control unit and sensors
2a Power supply
3 Auxiliary connections
4 SD memory card
CONTINUES
Tab. 1