Aqua Lung Black Ice BC - Manual (Page 18)

Table of Contents
© 2014 Apeks
DONNING AND ADJUSTMENT PROCEDURES
WARNING: Verify the tension of the cylinder band prior to every dive. Failure to do so may
result in the cylinder slipping during the course of a dive.
5. Check that the cylinder band is secure by pulling on the band while holding down the cylinder at the
valve. If the cylinder band moves, it is too loose. Check that the macro adjustment is set for the correct
size cylinder. Repeat steps 1-4 to tighten and secure the cylinder band.
1. Remove the weight pouches from the BC.
2. Disconnect the waist buckle and chest strap.
3. Ensure that the quick release buckles on both torso straps are securely fastened. While firmly holding
the torso strap where it connects to the BC lobe, fully extend each torso strap to its maximum length
by pushing straight up on the slide buckle.
4. While your dive buddy lifts and holds the BC/cylinder behind you, place your arms through the BC
torso straps as if you were putting on a jacket.
NOTE: If additional length is needed in the waistband, remove the webbing from the webslides.