Aqua Lung Black Ice BC - Manual (Page 13)

Table of Contents
© 2014 Apeks
1. Remove the inflator hose from the power inflator body by
gripping the grooved sleeve over the quick disconnect coupling
with your thumb and forefinger. Slide the sleeve back.
2. Remove the port plug from a MP port on the regulator using
an appropriately sized wrench.
WARNING: DO NOT connect the inflator hose to a
high pressure (HP) port (greater than 200 psi / 14 bar).
This may cause the hose to burst when pressurized,
which can result in serious injury. If you are unsure
which regulator port is medium pressure (MP) or
high pressure (HP), consult your regulator owner’s
manual or your dealer before attaching the hose.
3. Check to ensure the o-ring is present and in good condition.
Screw the threaded end of the hose into the port and tighten to
40 in-lbs. (4.5 Nm) with a 9/16” wrench.
ATTACHING THE MP HOSE TO THE FIRST STAGE