AIRLESSCO SS3650 - Manual (Page 15)

12 13
LINE STRIPING TIP CHART
NOTE: STRIPING TIPS SHOULD NOT BE USED FOR REGULAR SPRAYING.
• 1st 3-digits identifies it as a REV-TIP™ for airless line striping (Part Number 562-xxxST).
• 4th digit is the fan width - the number is half the fan width, e.g., 2means a 4" line width.
• 5th and 6th digits are for the orifice size and is measured in thousandths of an inch, e.g., 17 = 0.017 inch.
The higher the number, the larger the tip.
During use, high pressure will cause the orifice to grow larger. This destroys the pattern or will leave tailing or two heavy
lines on the outside of the pattern. REPLACE SPRAY TIP FREQUENTLY!
REV-TIP™
for Striping, Part Number 562-xxxST
REV-TIP™ protected By U.S. Patent No. 6,264,115. Other U.S. & foreign patents applied for.
TIP REPLACEMENT
TIP IDENTIFICATION
REV-TIP
TM
FOR STRIPING 562-XXXST
FAN WIDTH (6” FROM SURFACE) ORIFICE SIZE (INCHES)
INCHES MILLIMETERS .013 .015 .017 .019 .021
1-2 25-51 113ST 115ST 117ST
2-4 51-102 215ST 217ST 219ST 221ST
4-6 102-152 315ST 317ST 319ST 321ST
6-8 152-203 415ST 417ST 419ST 421ST
Striping paint Oil Base Oil Base Latex Latex Latex
REVERSIBLE STRIPING TIP SIZE CHART
PROBLEM CAUSE SOLUTION
Unit doesn’t prime Airleak due to:
•Loose suction nut
• Worn o-rings
•Hole in sucktion hose
Stuck or fouled balls
• tighten suction nut
• replace o-ring (106-011) on suction seat & o-ring (106-020)
below suction seat
• replace suction hose (331-290)
• service outlet valve suction assembly
Unit primes but has poor
or no pressure
Pressure set too low
Filter(s) are clogged
Outlet valve fouled/worn
Prime/pressure relief valve
bypassing
Packings and/or piston worn
• turn up pressure
• clean or replace gun filter, inlet filter, and/or manifold filter
• service outlet valve
• clean or replace prime valve
• tighten packing nut
• repack unit
Unit does not maintain
good spraying pressure
Blown spray tip
Packings and/or pistons worn
Upper seat worn
• replace spray tip
• repack unit
• replace upper seat
FIELD TROUBLESHOOTING