AIRLESSCO SP200 - Manual (Page 13)

Setup
3A0994E 13
Install Tip and Guard on Gun
1. Engage trigger lock.
2. Verify tip and guard parts are assembled in order
shown.
3. Screw tip and guard assembly on
gun. Tighten retaining nut.
Spraying Techniques
Preventing Excessive Tip Wear
• Spray should be atomized (evenly distributed, no
gaps at edges). Start at low pressure setting,
increase pressure a little at a time until you see a
good spray pattern, without tails.
• Spray at lowest pressure that atomizes paint.
• If maximum sprayer pressure is not enough for a
good spray pattern, tip is too worn. See Reversible
Spray Tip Selection Chart, page 16.
NOTE: If tails persist when spraying at the highest pres-
sure, a smaller tip is needed or the material may need to
be thinned.
Adjust Spray Pressure
This sprayer is set up for most airless spraying applica-
tions. Details on tip selection, tip wear, coat thickness,
etc. are provided on page 15.
NOTE: Motor only runs when gun is triggered. Sprayer
is designed to stop pumping when gun trigger is
released.
Align setting indicator with function symbol on Pressure
Control knob.
• Turning knob to right (clockwise), increases pres-
sure at gun.
• Turning it left (counter-clockwise), decreases pres-
sure.
• General spraying instructions are provided in Get-
ting Started with Basic Spraying Techniques section
of this manual, page 17.
( Mustang 2 )
ti15978a
ASM 500
ti15981a
retaining nut black rubber gasket and
guard
tip
ti8911a
metal seat
Use tip to align seat Tip must be pushed
all the way into guard
in guard
ti9574a
ti5606a
ti9313a
ti5592a
tails-gaps
at edges
pressure
good
spray pattern
too low