AIRLESSCO SP200 - Manual (Page 11)

Setup
3A0994E 11
Setup
1. Unscrew tip and guard assembly
from gun.
2. Uncoil hose and connect one
end to gun. Use two
wrenches to tighten securely
3. Connect other
end of hose to
sprayer.
NOTE: If hose is already connected, make sure connec-
tions are tight.
4. Turn OFF power switch.
5. Turn Pressure Control Knob
all the way left (counter-clock-
wise) to minimum pressure.
Prime and Flush Storage Fluid
NOTE: To spray lacquers with the SP300 and Mustang
3100, you must purchase lacquer conversion kit
256212, and follow priming procedure for oil-based
materials. The SP200 and Mustang 2400 units are not
intended for lacquers.
Before you use your sprayer for the first time or begin a
new spraying project, you need to prime the sprayer and
flush the storage fluid out of the sprayer.
Oil- or Water-based Materials
• When spraying water-based materials, flush the
system thoroughly with water.
• When spraying oil-based materials, flush the sys-
tem thoroughly with mineral spirits or compatible,
oil-based flushing solvent.
• To spray water-based materials after spraying
oil-based materials, flush the system thoroughly
with water first. The water flowing out of prime tube
should be clear and solvent-free before you begin
spraying the water-based material.
• To spray oil-based materials after spraying
water-based materials, flush the system thoroughly
with mineral spirits or a compatible oil-based flush-
ing solvent first. The solvent flowing out of the prime
tube should not contain any water.
• When flushing with solvents, ground pail and gun.
Read Grounding and Electric Requirements, page
7.
• To avoid fluid splashing back on your skin or into
your eyes, always aim gun at inside wall of pail.
1. Make sure the power switch is OFF
and the sprayer is unplugged.
ti9714a
ti9681a
ti9674a
ti11456a
SP300 &
Mustang 3100
SP200 &
Mustang 2400
ti2810a
ti9344a
ti2810a