AEC OFC Series - Manual (Page 3)

OFC Series Extrusion Control Units Page 3
Table of Contents
1
General Information ................................................. 9
1-1 Introduction
1-2 Necessary Documents
1-3 Models Covered
2
Safety ...................................................................... 11
2-1 Work Rules
2-2 Tools and Equipment Needed
2-3 Mechanical Installation
2-4 Safety Considerations
2-5 General Responsibility
2-6 Operator Responsibility
2-7 Maintenance Responsibility
2-8 Safety
3
Shipping Information ............................................. 19
3-1 Unpacking and Inspection
3-2 In the Event of Shipping Damages
3-3 If the Shipment is Not Complete
3-4 If the Shipment is Not Correct
3-5 Returns
4
Operation ................................................................ 21
4-1 Setup
4-2 Unit Calibration and Setup
4-3 Menu Structure