AEC TD4-400-500 Floor Mount Dryer - Manual (Page 10)

OPERATING MANUAL - TD4-400-500 DRYERS
Revision 10/3/01
Page 9
Turn disconnect on electrical panel to ON position and follow
the instructions below:
Microprocessor Control Panel
1. Power light indicates there is power on.
2. After initializing,
AEC rdY will be displayed.
3. Press START
to start the dryer.
4. To set the process air temperature:
Press SET
- right display shows set temp.
Change setting using arrow keys.
Press ENTER
to input new setting.
5. Left display indicates actual temperature
6. Right display shows dewpoint or set temp
Press TEMP
to display process air set temp.
Press D.POINT
to display dew point.
7. To set high temp alarm: (degrees over setting)
Press ALARM - right display shows setting.
Change setting using arrow keys.
Press ENTER
to input new setting.
8. Status block indicates heater on or fault
9. See Microprocessor manual for setting 7-day timer .
10. Configuration of the dryer parameters is done
using the setup button. See Microprocessor Control
manual.
These instructions are covered in detail in Microprocessor
Control Instruction Manual. Please read this manual before
proceeding further.
START-UP PROCEDURE