Method 2: using the flush mount – ACTi KCM-3311 User Manual

Page 10

Hardware Manual

Method 2: Using the Flush Mount

You can use the

PMAX-1008

flush mount to mount the camera on ceilings.

NOTE:

Due to continuous product improvements, the camera images on this documentation may

slightly differ from the actual camera that you received. Installation procedures remain the same.

Prepare the following:



PMAX-1008 Flush Mount



Drilling template



Screws (3)



Foam rubber pads (3)



Jig saw (not supplied)



Phillips screwdriver (not supplied)

To mount the camera, follow the procedures below:

1) Drill a Hole on the Ceiling

Drill a 184-mm diameter hole on the ceiling where you want to mount the camera, then route the

network cable through the hole.